|
I
want an Authorized
Representative to
contact me:
|
Philips: LPC211x
- LPC2114, LPC2124, LPC2119, LPC2129, LPC2194
|
|
|
Chip Feature
overview:
- 16/32-bit
ARM7TDMI-S microcontroller in a tiny LQFP64 package.
- 16
kB on-chip Static RAM.
- 128/256
kB on-chip Flash Program Memory. 128-bit wide interface/accelerator
enables high speed 60 MHz operation.
- In-System
Programming (ISP) and In-Application Programming (IAP) via
on-chip boot-loader software. Flash programming takes 1
ms per 512 byte line. Single sector or full chip erase takes
400 ms.
- EmbeddedICE-RT
interface enables breakpoints and watch points. Interrupt
service routines can continue to execute whilst the foreground
task is debugged with the on-chip RealMonitor software.
- Embedded
Trace Macrocell enables non-intrusive high speed real-time
tracing of instruction execution.
- Two
interconnected CAN interfaces with advanced acceptance filters.
- Four
channel 10-bit A/D converter with conversion time as low
as 2.44 us.
- Multiple
serial interfaces including two UARTs (16C550), Fast I²C
(400 kbits/s) and two SPIsTM.
- 60
MHz maximum CPU clock available from programmable on-chip
Phase-Locked Loop.
- Vectored
Interrupt Controller with configurable priorities and vector
addresses.
- Two
32-bit timers (with 4 capture and 4 compare channels), PWM
unit (6 outputs), Real Time Clock and Watchdog.
- Up
to forty-six 5 V tolerant general purpose I/O pins. Up to
9 edge or level sensitive external interrupt pins available.
- On-chip
crystal oscillator with an operating range of 1 MHz to 30
MHz.
- Two
low power modes, Idle and Power-down.
- Processor
wake-up from Power-down mode via external interrupt.
- Individual
enable/disable of peripheral functions for power optimization.
- Dual
power supply:
-
CPU operating voltage range of 1.65 V to 1.95 V (1.8
V +-0.15 V).
-
I/O power supply range of 3.0 V to 3.6 V (3.3 V +-10pct)
with 5 V tolerant I/O pads.
|
|
|
